【Product Name】Single-tube/double-tube hot and cold spray
【Rated voltage】110-220V/50-60Hz
【Rated power】800W
[Water cup capacity] 1L (recommended to fill 600-800ML of water, do not fill it up)
[Mist out time] about 3 minutes (hot spray)
About 10 seconds (cold spray)
[Instrument height] telescopic height 88-112cm (excluding spray tube)
Telescopic height 109-134cm (including spray tube)
1. All components are detachable for easy replacement. The first hot water tank can be cleaned, sterilized, descaled, safe and beautiful.
2. The hot and cold water tank is separated, and imported components are used, which is not easy to decay, and has no loss of atomizing sheet. The atomization time of titanium alloy atomizing sheet can reach 10,000 hours.
3. The thermal spray heating pipe uses high-quality stainless steel heating pipe, which does not rust.
4. The European-style water level detection type is adopted for the power failure without water, and the power is automatically cut off when there is no water.
5. Sufficient cold fog, hot and cold fog can be used at the same time to become warm fog
【Product Features】
1. Softens necrotic cells on the skin surface for removal during subsequent care routines.
2. It can open the pores and facilitate deep cleaning.
3. The steam can penetrate into the pores, softening the grease, blackheads, cosmetic residues and dirt accumulated in the pores for easy removal.
4. Steam can help the pores to excrete toxins and can temporarily soften wrinkles.
5. Promote blood circulation, replenish water in cells, improve cell metabolism and automatic repair.
【Steps for usage】
1. Put the host on the flat hidden desktop.
2. Take out the spray tube and place it in the mist outlet.
3. Press the hot water cup up and tighten
4. Add water to the hot water cup at the hot spray water inlet to below the highest water line; add water to the cold spray to the starting water level at the cold spray water inlet.
5. Plug in the power supply and press the switch to use. Special attention: If there is no water in the hot water cup or when too much water is added, the thermal spray switch will be activated, and the instrument will be automatically protected. (Anti-dry burning function)

Note: The most important thing to pay attention to in the cold spray method is the size of the fog and the spray time. Generally, it is ideal to control the time around 20 minutes.